This is a new, aftermarket, high security key for a 2014-2018 Ford Transit Connect Van cut to your key code. This key is guaranteed to be cut to the key code you provide. The Ford code series for this vehicle is 10001-11500, which means your key code will fit within this series.

This key is a transponder key, so you need to configure your car to recognize the new key. This usually requires a special tool to configure your cars computer. Your Ford dealership or a local locksmith that does automotive work will have this tool. If you have two working and unique keys for your Ford vehicle, then you may be able to configure your car to recognize the new transponder key using your cars On Board Programming feature. The instructions for On Board Programming are shown below. 

Don't hesitate to contact us with any questions you might have. Thanks!


On Board Programming Instructions:

NOTE:
A maximum of eight coded keys can be programmed to your vehicle; all eight can be IKT’s with
remote entry functionality.
1. Insert the first previously programmed coded keys into the ignition.
2. Turn the ignition from off to on. Keep the ignition on for at least three seconds, but no more
than 10 seconds.
3. Turn the ignition off and remove the first coded key from the ignition.
4. After 3 seconds but within ten seconds of turning the ignition off, insert the second previously
coded key into the ignition.
5. Turn the ignition from off to on. Keep the ignition on for at least three seconds, but no more
than 10 seconds.
6. Turn the ignition off and remove the second coded key from the ignition.
7. After three seconds but within 10 seconds of turning the ignition off and removing the
previously programmed coded key, insert the new un-programmed key (new key/valet key)
into the ignition.
8. Turn the ignition from off to on. Keep the ignition on for at least 6 seconds.
9. Remove the newly programmed coded key from the ignition.
10. If the key has been successfully programmed, it will start the vehicle’s engine and will operate
the remote entry system (if the new key is an Integrated Keyhead Transmitter).

If the key was not successfully programmed, it will not start your vehicle’s engine and/or will not
operate the remote entry features. The message center will display: NO KEY DETECTED. Wait 10
seconds and you may repeat Steps 1 through 8. If the failure repeats, bring your vehicle to your
authorized dealer to have the new key(s) programmed.
To program additional new un-programmed key(s), wait 20 seconds and then repeat this
procedure from Step 1.